CCTV Tester Pro Manual de usuario descargar pdf (Pagina 19)

CCTV tester PRO User’s Manual

Page.18.

Brightness: Setting the brightness of OSD menu and background.(0~7)

Address search: off / on Open or close the PTZ address search Menu.

a. Press or key to move the parameter we want to change.

b. Press or to change the value.

c. Press ENTER to save the change or press RETURN key to give up the change.

3.9 PTZ address scanning

Search up the ID of PTZ camera.

Note: Please isolate the PTZ camera with other PTZ cameras before searching up. Otherwise all the

PTZ cameras in the same system will pan at the same time.

Press keys to “Device setting” menu:

Press key to confirm after change “Address search:”

to “on”, which add address scan sub-menu. Press to switch the sub-menu as illustrated:

(

Note:

The system returns to “OFF” after shutdown, and the

scan sub-menu closes automatically. Set “ON” again for next

use.)

Press key to set: protocol, communication port,

communication rate, make them same as the PTZ camera

Press or key, the address values is constantly on the rise or decrease.

NEAR: The tester will search up the ID quickly and continuously(from 1 to 256). When the ID

is searched, the PTZ camera will pan right. At this time, please press any key to stop

searching up.

FAR: The tester will search up the ID quickly and continuously(from 256 to 1). When the

ID is searched, the PTZ camera will pan left. At this time, please press any key to

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 30 31

Sin comentarios

CCTV Tester Pro Manual de usuario Pagina 19