CCTV Tester Pro Manual de usuario descargar pdf (Pagina 17)

CCTV tester PRO User’s Manual

Page.16.

Depending on the type of camera connected to the CCTV testerPRO, the Video “Format: “ will

automatically change between NTSC and PAL, and the Video Level will automatically change

between IRE (Institute of Radio Engineers) and mV. NTSC signals measured in IRE units, PAL

signals measured in mV.

The Video Level should be within the indicated range. Levels that are too low will result in a

dim picture with reduced dynamic range. A Video Level that is too high will result in washed

out pictures with decreased. The CCTV testerPRO will display “Normal” when video levels are

1000mV±20%, “Exceed” or “Weak” will be displayed when video level out of 1000mV±20%.

3.5. Colorbar generator

(Output video at any mode)

Output or receive seven different forms of video color bar to test

monitor, video cable or other equipment.

a. Press the or key to select the parameter which

we want to change the value.

b. Press the or key to change the value.

c. Press ENTER key to save the change or press RETURN key to give up the change

3. 6 Cable Tester

Test LAN cable or telephone cable.

Connect LAN cable or telephone cable with the CCTV testerPRO and cable tester. And then the

connecting status, cable type and the sequence of wires will be displayed, as well as the serial

number of the cable tester kit

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 30 31

Sin comentarios

CCTV Tester Pro Manual de usuario Pagina 17